Researchers in China have traced how screen printing degrades copper-plated silicon heterojunction (HJT) solar cells and have proposed a modified screen design intended to limit the damage, according to a study published in Solar Energy.
Screen printing is standard for solar cell metallization, but in copper-plated HJT devices the process is more invasive than in conventional silver paste printing. Corresponding author Lang Zhou told pv magazine that silver paste screens leave only 2–5% of their area open, with an emulsion layer keeping the mesh off the wafer. Full-area photoresist coating, by contrast, typically uses a screen without emulsion coverage so that resist is deposited uniformly across the whole wafer, meaning the mesh contacts the wafer directly and extensively on every printing cycle.
Production data cited by the researchers showed conversion efficiency falling from 26.2% to 25.7% across 15,000 consecutive printing cycles. The losses were attributed mainly to reductions in open-circuit voltage and fill factor, while short-circuit current density and electrical resistance stayed largely unchanged. Minority carrier lifetime degradation rose from 0.61% with a new screen to 11.0% after 15,000 cycles.
Wear at the mesh knuckles
Using three-dimensional confocal microscopy, the team identified progressive wear of the screen mesh knuckles as the principal cause. As knuckles wear down, their contact area with the wafer grows, placing greater mechanical stress on the passivation layers beneath. Scanning electron microscopy showed no visible surface scratches, but photoluminescence measurements indicated increased recombination losses, pointing to damage at the amorphous silicon/crystalline silicon interface.
Emulsion buffer layer
To interrupt that direct contact, the researchers added an emulsion buffer layer to the screen and evaluated six patterns with emulsion coverage ratios between 2.9% and 16.6%. The results showed a trade-off between mechanical protection and photoresist coating uniformity, as higher emulsion coverage reduced damage but impaired ink distribution.
A coverage ratio of 4.7% gave the best balance, limiting minority carrier lifetime degradation to 0.41% after 10,000 printing cycles while maintaining relatively good coating uniformity. The authors attribute the improvement to the emulsion layer preventing the mesh from touching the wafer, thereby reducing cumulative mechanical damage to the sensitive passivation layers.
“The findings demonstrate that a relatively simple modification to screen design can substantially mitigate printing-induced degradation, offering a practical approach to improving the manufacturing reliability of copper-plated HJT solar cells,” Zhou said.
Momentum behind copper metallization
The work comes amid growing interest in copper contacts as a way to cut silver consumption in HJT production. In April 2026, researchers at China’s Nankai University reported a silver-free HJT cell at 25.2% efficiency, using plasma-induced interface engineering and copper electroplating to address adhesion, contact resistance and stability challenges at the ITO interface.
Separately, scientists at Germany’s Forschungszentrum Jülich reached 23.08% with a fully copper-metallized HJT cell, a relatively small efficiency penalty compared with its silver-metallized counterpart, while devices combining silver-copper paste on the front side with silver rear contacts reached 23.95%. Those findings underline copper’s potential to reduce silver use, although further improvements in processing and electrical performance are still required.
