A Jeep owner has built a rear-only portal axle for roughly one-fifth of the usual price by flipping a conventional differential upside down and combining a Ford axle housing with surplus military hardware.
Portal axles put a stack of gears behind each driven wheel rather than letting shafts and driveline components hang below the transmission and transfer case. That arrangement lets the axle tubes sit high and leaves very little hardware below the frame line, so a vehicle on tall tires can clear obstacles a conventional drivetrain would drag over. As automotive writer Andrew Collins has described, the idea is conceptually simple but the execution is substantial engineering. The obstacle has always been cost: a set from suppliers such as 74Weld typically runs about $20,000. Zeph Gage's rear unit comes in at roughly a fifth of that.
How the conversion works
Two-gear portals of the kind used on Humvees reverse the direction in which the input shaft turns. To compensate, Gage mounted the differential upside down so the driveline spins the correct way, then bolted a Yukon Gear and Axle third member to it, in effect turning low-pinion parts into a budget high-pinion assembly.
- Housing: Ford 9-inch axle
- Hubs: geared units from a Humvee
- Adapters: Jesse Haines Fabrication HMMWV portal adapters
- Third member: Yukon Gear and Axle
What the owner gains
The conversion adds about six inches of clearance. It also keeps full shock travel, which is difficult to achieve with portal axles, and lowers the load on the differential itself; Gage says that should make the assembly effectively bulletproof. Because the front end keeps its ordinary solid axle, the Jeep picks up clearance at the rear without the expense and complexity of converting both ends.
Why only the rear axle
Fitting a portal at one end only is a familiar trick in the remote-control rock-crawler scene. Leaving the front solid axle in place meant Gage did not have to solve the packaging problems that arise when portal axles are adapted to a vehicle that never left the factory with them. He also avoided restricting shock travel to make room, and ride height stays within reason. The finished XJ can drive over a five-gallon bucket and still have several inches to spare, so the rear is far less likely to hang up on obstacles the front can simply steer around.
Not an off-the-shelf kit
Considerable custom work went into the build, from homemade brackets and custom-tapped plates to a two-piece brake rotor matched to a Ford Fusion caliper. Gage chose the Fusion hardware partly because it carries an integrated electric parking-brake solenoid and partly for clearance. He explains how front and rear gearing were matched in a video from Outdoor Auto.
